Author Topic: Fuel gauge died.  (Read 7152 times)


  • Newbie
  • *
  • Posts: 44
  • Sym VS 125 with 150 engine
    • View Profile
Fuel gauge died.
« on: June 29, 2012, 04:03:05 AM »
After work last night I noticed the fuel gauge was below empty, was about quarter on the way to work. Filled up on the way home, but still no life. I checked the resistance at the wires at the gauge, was ok so replaced the gauge and works fine. I had noticed over the last few months that when filling the tank, the gauge would onlw go to about 1/4" below full. It is good to have a parts bike, but is this available as a spare part or do you have to buy the complete cluster? I guess the next one will be the float in the tank. This VS125 is either 2007 or 2008. If it had a trip meter it wouldn't be so bad.


  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: Fuel gauge died.
« Reply #1 on: January 16, 2013, 03:18:07 AM »
Hi, I have the same problem. The gauge was suddenly dead. I haven't yet time to check the fault but I'm afraid the the spare is expensive...

here you can find the part list. Unfortunately the instruments are "all-in-one"
« Last Edit: January 16, 2013, 09:56:00 AM by cicciopets »


  • Hero Member
  • *****
  • Posts: 1518
  • Another Dealer hard at work...
    • View Profile
Re: Fuel gauge died.
« Reply #2 on: February 07, 2013, 09:44:28 PM »
Usually the problem is just a sticky float in the tank - remove float assembly, and loosen the swing arm by gently tapping on it where it is attached to the sending unit- loosen the little clip
Also suggest checking the connection behind lower right protect strip
« Last Edit: February 07, 2013, 09:52:33 PM by ootscoot »
Ooty's Scooters - Santa Barbara, CA.
SYM Dealer, SYM rider, SYM owner - got them all!

An Error Has Occurred!

Call to undefined function split()